General Temperature Sensor (GTS 01)
Primarily intended for immersion application with low cost and can accommodate with the wide range of sensing elements. The design may vary based on application and your need.
Typical construction of sensing element has been housed inside a seamless tube or mineral insulated cable based on temperature range and extension cable will help reach the controller/transmitter which locates far from the process.
Basically, the type of sensor will be as RTD, Thermocouple and Thermistor, where those will be widely applied at low-temperature range application such as chiller monitoring, refrigerating, air conditioning, piping temperature measurement till LNG tank monitoring system.
RTD Specifications
Tolerance Class A, B
Resistance at 0°C 100/1000 Ohms
Standard
IEC 60751
Note: Other sensor type and tolerance will be available upon request.
Thermocouple Specifications
Sensor type K (NiCr-Ni)
J (Fe-CuNi)
T (Cu/Cu-Ni)
E (NiCr-CuNi)
Standard IEC 60584
Tolerance Class 1
Note: Other sensor types will be available upon request
Sheath material: SS316
Sheath Diameter: Ø1.6 mm to Ø12.7 mm
Extension Wire
FEP insulated 400°F (204°C)
PFA insulated 500°F (260°C)
TFE insulated 500°F (260°C)
Fibreglass insulated 900°F (482°C)
PVC insulated 221°F (105°C)
Standard wire size AWG 24, AWG 26
Note: Other wire types such as stainless braided (SSOB) on wire insulation and sizes are available upon request.
Compression Fitting size as per below
1/2″ NPT M (as standard)
3/4″ NPT M
M20x1.5P
Available others size upon request
Temperature Controller (TC Series)
PID Temperature controller which actually able to set temperature point for cut off/start up the application as automatically driving signal from the temperature sensor. In the other hand, you can easy to translate the signal from display panel which will show process temperature. It will have up to 2 channels which allow monitoring for 2 different sensors in one place. Since all of the control buttons are visible on the front, it will be the benefit for you to access manual setting easily when you need to be. The most PID temperature controller will widely be used in industry which seriously need to be monitoring temperature for few reasons since you are unable to reach easily for process temperature. Also available for those all-purpose temperature controllers will also be used in your garden to control ambient temperature which actually can minimize your worries whether your plant gets enough temperature or not as well as for your car engine especially for diesel engine startup issue.